Manufacturing

Fifteen days, five stages, one approved drawing.

A custom wheel is a manufacturing promise. Here is exactly what happens between the email and the crate, and where you get to stop us.

01

Build sheet

Year, make, model, trim, brake package and ride height. If you already know the offset and width, send those instead. We check arch clearance, strut clearance and caliper sweep before anything is quoted.

Day 0
02

3D approval

The set is rendered on your vehicle geometry — diameter, width, offset, lip depth, finish. You approve it in writing. This is the step that stops wrong wheels being made, and it is why the fitment guarantee can exist.

Day 1–2
03

Forging

A 6061-T6 aluminium billet is heated and pressed. The grain follows the spoke rather than being cut across it, which is the difference between a forged wheel and a machined one.

Day 3–5
04

Machining

Five-axis machining sets the bolt pattern, centre bore, offset, width and lip depth. Multi-piece assemblies are drilled and torqued to the approved sheet.

Day 5–11
05

Finish and inspection

Surface preparation, then the specified finish. Each wheel is checked for radial and lateral runout, balanced, and photographed. Those photographs are sent before packing.

Day 11–15
Finished two-piece forged wheel fitted to a grey performance sedan
Stage 05 · finished and fittedForging, machining, finish — then the wheel it was drawn around.
Quality control

Six checks before a crate closes.

RunoutRadial and lateral runout measured on the finished wheel, not the raw forging.
BalanceStatic and dynamic balance before the tyre is fitted.
Bore and patternCentre bore, bolt circle and offset checked against the approved sheet.
SurfaceFinish inspected under raking light for inclusions, thin coats and colour drift.
HardwareBeadlock rings, bolts and centre caps torque-checked and bagged per wheel.
PhotographsFour images per wheel, sent for approval before the crate is closed.
Material

6061-T6, and nothing else.

Every wheel we make starts as 6061-T6 aluminium. It forges predictably, machines cleanly and takes a structural weld when a multi-piece centre needs one.

We do not offer a cast option, a flow-formed option, or a cheaper alloy for the same design. If a design cannot be forged within a safe wall thickness, we say so and change the design rather than the material.

What is warranted

Start at the build sheet.

Production 15 days from 3D approval. Air freight 10–15 days, sea freight 25–45 days.